Auto Paint-2K Solid Colors-Maxytone Series

car paint/paint/auto paint Maxytone 2K Solid Colours: Substrates: Dried and sanded existing finishes, MAX 1k or 2K Primer Surface Cleaning: Remove wax, silicon and other contaminations with degreaser. Mixing Ratio <18°C 18-24°C MAX-2K Solid Colors 100 parts MAX-2K Solid Colors 100 parts MAX-3611 Fast Hardener 50 parts MAX-3612 Standard Hardener 50 parts M-1 Thinner 10-30 parts M-1 or M-2 thinner 10-30 parts 25-30°C >30°C MAX-2K Solid colors 100 parts MAX-2K Solid Colors 100 parts MAX-3612 Standard Hardener 50 parts MAX-3613 Slow Drying Hardener 50 parts M-2 or M-3 Thinner 10-30 parts M-3 Thinner 10-30 parts Pot Life: MAX-3611:2 hours, 25°C;MAX-3612 or MAX-3613:4 hours, 25°C NO.of Coats: 2-3 coats,40-60um Flash-off time: At 25°C,5-10 minutes between coats, allow 15-20minutes flash-off time before baking Sandability and Polishabiility: Dust particles and minor damages or sagging area can be sanded out with P2000 paper wet after the finish is completely dry. Compound and polish to restore gloss. Spray Gun & Pressure Gravity Feed 1.2-1.5mm 3-5kg/cm2 Siphon Feed 1.4-1.7mm 3-5kg/cm2 Drying Time: Temperature Dust Free Tack Free Dry to Handle Thorough Dry 25°C 45 minutes 2-3 hours 10 hours 7 days 70°C 5 minutes 10 minutes 25 minutes 60 minutes Shelf life: 2 years in original sealed can at cool and dry place at 20°C Packaging: 1L, 3.75L Note: 1. Remains of water in the sanding marks is harmful to the property of paint film. If the substrate is prepared with P800-1000 wet, blow dry the surface with spray gun. 2. At temperature lower than 15°C, air-dry at ambient temperature is not recommended. Allow a full bake at 60°C. 3. At ambient temperature higher than 30°C, add Retarder Solvent into thinner to avoid blushing. Details please refer to the technical data sheet of Retarder Solvent. 4. In the event of fisheyes during application, add 0.5-1% Anti Silicon in the paint remained and re-spray the affected area. 5. In the overspray area of new and existing finish, apply directly Thinner SRA to achieve an invisible transition. Details please refer to the technical data sheet of Thinner SRA. 6. The products mixed with hardener should be used up soon and can not restore for future use. 7. Clean equipments immediately with solvent after application.